Indesit I55TM4110X1 Instrucciones De Uso página 13

SHIPMENT AND REPOSITIONING
Transportation and changing of Installation position
• Original package and foam may be kept for re-transportation (optionally).
• You should fasten your fridge with thick package, bands or strong cords and follow the instructions
for transportation on the package for re-transportation.
• Remove movable parts (shelves, accessories, vegetable bins etc.) or fix them into the fridge against
shocks using bands during re-positioning and transportation.
Carry your fridge in the upright position.
Reversing the door opening direction
• It is possible to change the opening direction of your appliance's doors. If you want to do this, plea-
se contact your nearest authorized service.
BEFORE CALLING YOUR AFTER SALES
SERVICE
If your refrigerator is not working properly,it may be a minor problem, therefore check the following,
before calling an electrician to save time and money.
What to do if your refrigerator does not operate ;
Check that ;
• There is no power ,
• The general switch in your home is disconnected ,
• The thermostat setting is on "•" position ,
• The socket is not sufficient. To check this, plug in another appliance that you know which is working
into the same socket.
What to do if your refrigerator performs poorly ;
Check that:
• You have not overloaded the appliance ,
• The doors are closed perfectly ,
• There is no dust on the condenser ,
• There is enough place at the rear and side walls.
If there is noise ;
The cooling gas which circulates in the refrigerator circuit may make a slight noise(bubbling sound)
even when the compressor is not running. Do not worry this is quite normal. If these sounds are
different check that ;
• The appliance is well levelled ,
• Nothing is touching the rear.
• The stuffs on the appliance are vibrating.
If there is water in the lower part of the refrigerator ;
Check that ;
• The drain hole for defrost water is not clogged(Use defrost drain plug to clean the drain hole)
Recommendations
• W hile power cut, to prevent any compressor problem you should plug out the refrigerator. You
should delay plugging in 5 – 10 minutes after you power supply. If you plug out the refrigerator for a
reason you should wait at least 5 min to replug. It is important for avoiding damage to refrigerator's
components.
• The cooling unit of your refrigerator is hidden in the rear wall. Therefore, water droplets or icing
may occur on the rear surface of your fridge due to the operation of the compressor in specified
intervals. This is normal. There is no need to perform a defrosting operation unless the icing is
excessive.
EN - 13