Publicidad
Idiomas disponibles
Idiomas disponibles
Setting multiple programmes
∙ The unit may be set for a maximum of 2 programmes running consecutively, e.g. defrosting, followed by the microwave or
grill function.
∙ Any defrosting, microwave and grill programmes as well as the combination of the programmes may be selected.
∙ A beep signal is heard at the end of each programme segment, when the next one starts. 5 beeps indicate that the entire
programme has finished.
∙ Example:
To defrost food for 5 minutes, followed by microwave cooking at 80 % for 7 minutes.
1. Press
twice. The display shows dEF2.
2. Turn the rotary control to select a defrosting time of 5 minutes.
3. Press
4. Press
to confirm.
5. Turn the rotary control to set a cooking time of 7 minutes.
6. Press
to start the programme.
Timer
∙ The microwave can be pre-programmed in such a way that it starts operating at a pre-determined time.
∙ This function can be combined with any programme (except defrosting and quick-start).
∙ However, always check first that the time on the unit has been correctly set prior to using the timer delay function.
1.
Set the time (see Setting the clock) if necessary.
2.
Set the desired programme. Do not press the
3.
Press
. The current time is displayed and the hour display flashes.
4.
Turn the rotary control to select the desired hour setting at which you want the unit to start operating.
5.
Press
. The minute display flashes. Turn the rotary control to select the desired minute setting at which you want
the unit to start operating.
6.
Press
. The selected programme will start at the pre-programmed time, when 2 acoustic signals will be heard.
Childproof safety device:
This safety device prevents children from operating the appliance without supervision.
To activate the safety device, press
To switch off the safety device, press
Note: Should you experience a problem switching the appliance on, first verify that the safety device is not activated.
∙ Before cleaning the appliance, ensure it is disconnected from the power supply and has cooled down completely.
∙ Do not clean the unit with water. Make sure that no water - however small an amount - is allowed to enter the ventilation
slots on the inside or outside of the unit. Do not use any steam cleaning appliances.
∙ The interior surfaces must be cleaned thoroughly after each cycle of use. Any food residue must be removed. The inside
of the door, the door frame, the roller ring/drive unit and the guiding track area underneath the glass turntable must be
kept clean at all times.
∙ The entire unit may be wiped with a slightly damp lint-free cloth and a mild household detergent. Wipe thoroughly dry
afterwards.
∙ Do not use abrasives or harsh cleaning solutions. Commercially available sprays specifically developed for cleaning
conventional baking ovens are not to be used.
∙ The grill rack, turntable and roller ring/drive unit may be cleaned in hot soapy water.
22
twice. P80 starts flashing in the display.
for 3 seconds. The symbol
again for 3 seconds. The symbol
key yet.
appears on the display.
disappears.
Cleaning
Publicidad
