Publicidad
Idiomas disponibles
Idiomas disponibles
Safety / Preparation
underestimate the dangers. Please always keep
the product out of the reach of children.
This device may be used by children aged
8 years and up, as well as by persons with re-
duced physical, sensory or mental capacities,
or lacking experience and / or knowledge, so
long as they are supervised or instructed in
the safe use of the device and understand the
associated risks. Do not allow children to play
with the device. Cleaning and user maintenance
must not be performed by children without
supervision.
Avoid the risk of fatal injury
from electric shock
Ensure that a qualified electrician, or a person
trained to carry out electrical installations,
performs the electrical installation.
Always check the light, power supply, and
mains cable for damage before plugging it in.
Never use the light if it shows any signs of
damage.
A damaged mains cable indicates a life-threat-
ening danger due to electric shock. In the event
of damage, repairs or other problems with the
light please contact the service centre or a
qualified electrician.
Prior to installation, remove the fuse or switch
off the circuit breaker (0 setting) in the fuse box.
Prior to installation verify the mains voltage on
site corresponds with the operating voltage
required for the light (see "Technical data").
Ensure that the light does not come into contact
with water or other liquids under any circum-
stances.
Never open any of the components of the elec-
trical equipment or insert any objects into the
same components. This will pose a risk of fatal
injury from electric shock.
Do not install the light on a wet or conductive
substrate!
14 GB/IE
Prevent fire and
injury hazards
RISK OF INJURY!
Check the light for damage immediately after
unpacking.
Do not mount the light with defective lamps
and / or lamp lenses. In this case contact the
service centre for a replacement.
Do not look directly into the light source (light
bulb, LED etc.).
Do not use optical instruments to look at the light.
The light's illuminant is not replaceable. The en-
tire light needs to be replaced if the illuminant
reaches the end of its service life.
This light is not suitable for external
dimmers or electronic switches.
Safe working
Mount the light so that it is protected from
moisture and dirt.
Carefully prepare for assembly and allow your-
self adequate time. Organise all parts and any
necessary additional tools or materials before
starting so they are easy to reach.
Always be attentive! Always pay attention to
what you are doing and use common sense.
Never install the light if you are having difficulty
concentrating or do not feel well.
Preparation
Required tools and material
The tools and materials specified are not included.
This information and these values are non-binding
and are only provided as a reference.
The nature of the material is determined by the
individual local conditions.
Publicidad
