Publicidad
Idiomas disponibles
Idiomas disponibles
7
When you turn off the tool, the chain will continue to run for a few sec-
onds. Wait for the chain to stop. Do not touch or block the moving chain.
Doing so poses a hazard!
1.
If the chainsaw stops working after extended use and you see a slow flash, it is an indica-
tion of undervoltage protection, which means that the battery is flat. Recharge as soon as
possible.
2.
If you encounter difficulties during branch cutting, during the pruning process, release the
trigger to stop the chain, then remove the bar from the branch, restart the chainsaw and
continue cutting.
The chainsaw must not be moved sideways during cutting, so as not to damage
the bar and chain.Never move the chainsaw from side to side when it is stuck.
198
Art. 616 / Art. 617
Chainsaw Magma E-100 LM / E-150 LM 21 V
Usage
Art. 616 / Art. 617
Chainsaw Magma E-100 LM / E-150 LM 21 V
Usage
Reading the LED display
To determine the battery charge level and display the duration of the cut, the chainsaw has a
handy easy-to-read LED display.
Display
For further information about the product, please contact info@stockergarden.com
7
Description
The battery charge level is indicated by a number
between 0 and 100.
Indicates the number of seconds (below) and
minutes (above) for which the chainsaw was used.
199
Publicidad
