Publicidad
Idiomas disponibles
Idiomas disponibles
REMOVING TRANSIT BOLTS
•
Remove all the transit bolts at the back of the machine with tools.
•
Plug the holes with the transit bolts caps supplied.
NOTE: Strong vibration, noise or failures may occur if the transit
bolts are not removed.
•
Keep the transit bolts for future transportation. Whenever the
machine is transported, the transit bolts must be refitted.
INSTALLATION
INSTALLATION PLACE REQUIREMENT
•
A concrete floor is the most suitable installation surface for a
washer-dryer, being far less prone to vibration during the spin
cycle than wooden floorboards or carpeted surface.
•
The machine must be level and securely positioned. The distance
between the machine and wall must be more than 10 cm.
•
To avoid vibrations during spinning. the machine should not be
installed on soft floor coverings.
LEVEL ADJUSTMENT
The machine must stand perfectly level on all four feet to ensure safe
and proper operation.
Incorrect installation may increase electricity and water consumption
and may cause the machine to move about.
To do these when the machine is not level:
•
Using the spanner turn locknut in clockwise direction. Then turn
locknuts together with adjust feet to unscrew.
•
To avoid vibrations during spinning, the machine should not be installed on soft floor coverings.
NOTE: Vibration and noise may occur if the locknuts do not sit firmly up against the houses.
51
Publicidad
