Publicidad
Idiomas disponibles
Idiomas disponibles
DRAIN HOSE CONNECTION
1. Direct into a sink
If the outlet spigot has not been used before, remove any blanking plug that may be in place.
Push the drain hose onto the spigot and secure with a clip if required, ensure a loop is formed in the
drain hose to prevent waste from the sink entering the washer-dryer.
If required, the drain hose can be extended to a length of 4m.
2. Connected securely to a standpipe
Firstly, form a hook in the end of the drain hose using the "U" piece supplied.
Place the drain hose into your standpipe, which should have an internal diameter of approximately
38mm thus ensuring there is an air brake between the drain hose and standpipe.
When discharging into a standpipe ensure that the top fo the standpipe is no more than 90cm and
no less than 60cm above floor level.
52
Publicidad
