Publicidad
Idiomas disponibles
Idiomas disponibles
CLEANNESS AND MAINTENANCE
CLEANING THE EXTERIOR
Clean the exterior with a mild non-abrasive cleaning agent or soap and
water using a well wrung-out cloth. Wipe dry with a soft cloth.
Do not use solvents, abrasive cleaners, glass cleaners or all-
purpose cleaning agents.
These might damage plastic surfaces and other components
because of the chemicals they contain.
THE WASHING DRUM
Clean the drum every 3 months by using the "Drum clean" program.
CLEANING THE DRAWER
Remove detergent residues regularly. Clear the drawer following these:
•
Pull out the drawer until a resistance is felt. Press down the release catch
and at the same time pull the drawer right out of the machine.
•
Remove the siphon from compartment and clean it.
•
Clean the dispenser using a brush and warm water.
CLEANING THE DRAWER HOUSING
Use a bottle brush to remove detergent residues inside the drawer housing.
CLEANING THE WATER INLET FILTER
Use pointed nose pliers to withdraw the plastic filter. Clean, put back and secure.
This filter should be checked every 6 months or so, or more often if there are frequent interruptions
to the water supply.
NOTE: The filter must be put back in place after cleaning.
CLEANING THE DRAIN PUMP FILTER
1. Disconnect the machine from
the mains electricity supply
and open the lower cover
with a screwdriver.
NOTE: The filter should be cleaned every 2 months or when there is fault that the "E03" is on the
screen.
3. Place a container under
the pump.
Unscrew and remove the
filter.
59
2. Clean the filter carefully.
Publicidad
