Publicidad
Idiomas disponibles
Idiomas disponibles
Figure 3 Wiring
Wiring
Testing and Operating
After installation, test the system to verify that each
signal operates, and establish a program for periodic
testing of the device. Provide copy of these instructions
to all operating personnel.
Replacing the LED Lamp
SHOCK HAZARD – To avoid electric shock, disconnect
the power and allow the lamp to cool.
To replace the lamp:
1.
Remove the set screw located at the bottom of the
dome.
2.
Grasp the top of the dome and push it down while
turning dome counterclockwise.
3.
Remove the dome and ensure that the gasket
between the dome and base is secured.
2645 Federal Signal Drive, University Park, Illinois 60484
Additional translations available at signaling.fedsig.com
Traducciones adicionales disponibles en signaling.fedsig.com
Customer Support 1-800-344-4634+1-708-534-4756, iordersup@fedsig.com
Technical Support 1-800-755-7621+1-708-587-3587, signalsupport@fedsig.com
signaling.fedsig.com
2
121SLED
1/2" conduit
(not supplied)
Wiring
Black to Line
(L or L1)
White to Neutral
(N or L2)
Green/yellow to Earth
(Ground)
Wire nuts not supplied.
Junction box
(not supplied)
4.
Grasp the lamp near the base and gently push
toward the socket while turning counterclockwise.
5.
Insert the new lamp while gently pushing it toward
the socket and turning clockwise.
6.
Before replacing the dome, ensure that the gasket
is properly seated on the housing base.
7.
Place the dome over the base and align the
recesses inside the dome lip with the four pins
on the base. Push down on the dome and turn
clockwise until it locks in place (approximately
3/4").
8.
Replace the set screw on the bottom of the dome.
9.
Test the light for proper operation.
Maintenance and Service
Technical Assistance: Contact our Technical Support
Team at +1 708-587-3587 or signalsupport@fedsig.com.
Repair Service: A return authorization is required. Contact
your Authorized Distributor or Federal Signal Customer
Support. Defective products under warranty will be
repaired or replaced at Federal Signal's discretion.
Product Returns: Returns require authorization from
Federal Signal. Contact your Authorized Distributor for
more information on our return policy or to request a
return.
Federal Signal signaling.fedsig.com
Publicidad
