HAEGER Pure Ice INOX Instrucciones De Uso página 10

Using your Ice Maker
1. Ensure that the drain plug at the bottom of water reservoir is closed well.
2. Plug the ice maker into the wall outlet, the "ICE" indicator blinks.
NOTE: Please make the ice maker be rested for 30 minutes before plug if it has been
moved.
3. Open the top lid and remove the ice basket.
4. Fill the water reservoir with drinking water.
NOTE: Do not fill above the MAX water level mark.
5. Replace the ice basket and close the top lid.
6. Press "ON/OFF" key, and the "POWER" indicator lights solidly. At that time, press
"SELECT" key to select the ice size. If need to clean the appliance, press "SELECT" key
to select "CLEAN" function under standby mode.
7. The ice-making cycle will last approximately 7-15 minutes, depending on the ambient
temperature and water temperature.
8. The ice-making cycle starts with water being pumped into the ice tray situated below
the evaporator. Over the next 7-15 minutes ice forms on the evaporator. Once this has
completed, the ice tray will tilt backwards and the remaining water in the ice tray is
drained back into the water reservoir. The ice cubes are then dropped from the
evaporator and pushed forward into the ice basket by the ice shovel. The ice tray will
automatically move back into position under the evaporator and start the next cycle.
9. The "ICE FULL" indicator will light up when the ice basket is full and then the ice maker
will stop the ice-making cycle automatically. Gently remove the ice from the ice basket
with the ice scoop. About 7.5 seconds later, the ice maker will restart its ice making
function automatically.
10. The "ADD WATER" indicator will light up when the water reservoir is lack of water and
the ice-making cycle will stop automatically. At that time, remove the ice basket and
add water to the water reservoir, and then press "ON/OFF" key again to restart the
ice-making cycle. The appliance will start working automatically after about 20minutes
if the operator forgets to restart the appliance after refill.
11. When you have got your desired amount of ice, stop the ice making cycle by pressing
the "ON/OFF" key and unplug the unit from the wall outlet.
12. Open the top lid and transfer the ice to a freezer.
13. Allow the ice maker to wall up to room temperature.
14. Suggest replacing the water a week. Please empty the water reservoir if the ice maker
is not used for a long time.
English - 8 -