HAEGER Pure Ice INOX Instrucciones De Uso página 11

Cleaning and Maintenance
To keep your ice tasting fresh and your ice maker looking great, we recommend cleaning
your ice maker at least once per week.
1. Stop the ice-making cycle by pressing the "ON/OFF" key. Wait five minutes and unplug.
2. If residual water is found in the ice tray, gently push the ice tray back so that all water
drains into the water reservoir.
3. Move the appliance forward to a place 60mm away from the working table and open
the drain plug to drain out excess water (see Fig.4, Fig.5 and Fig.6).
4. Check and make sure the drain plug must be closed well. Fill the water reservoir with
clean water, press "SELECT" until the 'CLEAN' indicator flashes, then press the "ON/OFF"
key, the pump will start to pump water and keep running for 6 minutes, and it will enter
into standby condition after running for 6 minutes, finally, open the drain plug and
empty the water.
5. Remove the ice basket.
6. Clean the ice maker interior with a soft cloth soaked with warm water and vinegar, then
rinse with clean water and then drain all the water.
7. Replace the drain plug well in position. Wash the ice basket and ice scoop in warm
soapy water. Rinse and dry.
8. Clean the exterior of the ice maker with a soft damp cloth. Use a mild dishwashing soap,
if necessary.
NOTE: 1) Do not use organic solvent, boiled water, detergent, strong acid and strong
alkali etc. for cleaning. 2) Do not clean the evaporator.
9. Please empty the water reservoir and dry it for storage if the ice maker is not used for
a long time.
Fig.4
English - 9 -