Publicidad
Idiomas disponibles
Idiomas disponibles
Troubleshooting
Problem
The indicator ADD
WATER turns on.
The indicator ICE
FULL lights up.
The ice collects
together.
The ice-making
cycle seems normal
but no ice is
produced.
Fig.5
Possible causes
1. Low water level or lack of
water
2. The water screen at the
bottom of water reservoir is
blocked.
3. Pump malfunction.
1. Ice basket is full and the
infrared light is blocked by
the ice.
2. Infrared light-emitting diode
& light-receiving diode do
not work
Making ice takes too much time.
The water in the water reservoir is
of too low temperature.
The ambient temperature or
water temperature is too high.
English - 10 -
Fig.6
Solution
1. Stop making ice, refill water and
then press "ON/OFF" key to
restart ice-making cycle.
2. Do cleaning.
3. Send it to the authorized
department for repair.
1.Remove the ice from ice basket.
2a. Wipe up the foreign objects on
the
infrared
diode & light-receiving diode
and restart the ice maker.
2b. Call Customer Service if the
infrared light-emitting diode &
light-receiving diode still cannot
work after wiping up the
foreign objects on them and
restarting the ice maker.
Stop making ice and restart the ice-
making cycle after the ice melts.
Fill the water tank with water
temperature between 8℃ and 25℃.
Start the ice-making cycle at an
environment
temperature less than 32°C and fill
the water reservoir with some cold
water.
light-emitting
with an ambient
Publicidad
