Publicidad
Idiomas disponibles
Idiomas disponibles
Installations
Before installing your refrigerator drawer, you must do the following:
•
Remove the exterior and interior packing.
•
Before connecting the refrigerator to the power source, let it stand upright for approximately 2 hours. This will reduce
the possibility of a malfunction in the cooling system from handling during transportation.
•
Clean the interior surface with lukewarm water using a soft cloth.
•
This appliance is intended to be used in household and similar applications such as
•
Staff kitchen areas in shops, offices and other working environments;
•
Farm houses and by clients in hotels, motels and other residential type environments;
•
Bed and breakfast type environments;
•
Catering and similar non-retail applications.
•
When disposing your appliance, please choose an authorized disposal site.
Anti-tip bracket installation
To avoid the risk of serious personal injury or damage to the appliance due to the instability of the appliance, it must be
fixed to the floor with anti-tip brackets and screws(supplied). Before installing, carefully read these instructions.
1. Take the fixing brackets(2pcs) and the expansion
bolts(2pcs) out of the instruction packet.
2. Drill holes into the floor according to the dimensions
shown below. This will allow you to fix the brackets
to the floor. According to the size and location, the
holes on the floor should be Ø0.39" (10mm).
TIP: Use painter's tape to judge how deep of a hole you are
drilling. First, cut a piece of painter's tape several inches
long. Then, place the tape on your drill bit at the depth of the
expansion bolts shield to drill. Once you reach the tape, you
know when to stop drilling. Don't drill too deep.
12.52" (318mm)
8.07" (205mm)
Top View
3. (A) Next insert the expansion bolt into the drilled
hole. Make sure it is flush to the floor.
(B) Unscrew the nut, washer and lock ring from the
screw.
A
8
Min: 0.87"/22mm
Max: 1.77"/45mm
Tape
B
4. Next, align the bracket hole with the screw and
reattach the washer and lock ring. Finally, tighten the
nut with a wrench or socket to the maximum. As you
tighten the shield, it will bend outwards, creating an
anchor that provides extra security for your unit.
5. Push the appliance back into its place, Ensure that
the bottom of the opening slides under the bracket,
as shown in the example below.
If the unit is not stable, pull back the appliance and
repeat the previous step until the unit is stable. Note: If
the unit is relocated, the bracket must be removed and
re-installed to its new location.
Publicidad
