Publicidad
Idiomas disponibles
Idiomas disponibles
Installations (continued)
Installing The Handle
1.
Locate the handle over the pins on the door panel.
2. Fix the handle by tighten the screw.
This appliance is designed to be for free-standing installation or built-in (fully recessed) (Refer to sticker location
the back of this appliance).
Important Information
This appliance is designed to be for free standing installation or built-in (fully recessed) (Refer to sticker location the back
of this appliance).
This appliance is intended to be used exclusively for the storage of wine or beverages.
•
Place your aplliance on a floor that is strong enough to support it when it is fully loaded. To level your appliance,
adjust the front leveling leg at the bottom of the appliance.
•
This appliance is using flammability refrigerant. So never damage the cooling pipework during the transportation.
Locate the appliance away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct sunlight may
affect the acrylic coating and heat sources may increase electrical consumption. Extreme cold ambient temperatures may
also cause the unit not to perform properly.
•
Avoid locating the unit in moist areas.
•
Plug the appliance into an exclusive, properly installed-grounded wall outlet. Do not under any circumstances cut
or remove the third (ground) prong from the power cord. Any questions concerning power and/or grounding should be
directed toward a certified electrician or an authorized Products service center.
Please make sure to follow these dos and don'ts when using the cabinet:
•
Don't overload the items in the cabinet.
•
Don't open the door unless necessary.
•
Don't cover shelves with aluminum foil or any other material which may prevent air circulation.
•
If the appliance is stored without use for long periods, it is suggested to leave the door ajar after a careful cleaning to
allow air circulation inside the cabinet. This will help to avoid possible formations of condensation, mold, or odors.
•
In case the appliance loses power or gets unplugged, it is important to wait for 3-5 minutes before starting it again.
The cause for starting the appliance immediately can add more pressure to an already high-pressure compressor
causing damage to the compressor due to an overload of pressure.
9
Publicidad
