Publicidad
Idiomas disponibles
Idiomas disponibles
Trouble
- During closing of the pressing tongs, a marked ridge is created on the compression sleeve.
Cause
- Damaged or worn pressing tongs/pressing contour.
- Incorrect pressing tongs (pressing contour, size) inserted.
- Unsuitable matching of compression sleeve, pipe and support sleeve.
Trouble:
- Pressing jaws close unevenly when the pressing tongs are not loaded.
Cause:
- Pressing tongs have been dropped, compression spring is bent.
IMPORTANT!
The maker will not take responsibility for damage or malfunction as a result of the Testing
Pump being incorrectly used or, applied for a purpose for which it was not intended.
For ordering spare parts, please refer to the Spare Parts Drawing and note the needed num-
ber.
According to Waste Electrical and Electronic Equipment directive (WEEE), these ones
must be collected and arranged separately. If you have to throw them out, please, do not use
the usual rubbish. Please, contact your distributor for free recycling.
The maker guarantees to the machine owner 12 months against any manufacture defect.
This guarantee does not cover the parts wich are consumables.
Note: to apply the guarantee it is necesary to send the "GUARANTEE CERTIFICATE" duly
filled within one week after purchased the machine to the maker.
16
NOTES
GUARANTEE
Publicidad
