Miniso MG35 Manual Del Usuario página 9

7.Wired mode
①Cable support: PC device /Switch host dock /PS3 host/smart TV;
②PC cable connection
Use a USB cable to connect the controller to the computer. After the
connection, the controller LED1 lights up, and the default mode is
X-INPUT.
Press and hold the HOME button for 5 seconds to switch to D-INPUT
mode. At this time, the controller LED2 lights up;
It is recommended to play games on Steam platform, pay attention to
the "Steam- Settings - controller - common controller Settings" check
the support options;
③NSwitch cable connection
When connecting the NSwitch base, make sure that the "Wired
connection for Pro handle" is enabled in the system Settings of the
NSwitch host.
Use the provided TypeC wire to connect the handle and the NSwitch
base. After the connection is successful, the corresponding LED light
will be on;
④PS3 host/Smart TV cable connection:
Plug in the USB cable to connect the PS3 host/smart TV. After the
connection, the corresponding LED light on the handle will be steady
on;
8.Control of the magic light strip
①Turn on the magic light bar default to the left and right color breath-
ing change;
②Press and hold down the two rockers at the same time to control
the light effect switch: left and right color change - left and right color
unchanged -Turn off the light effect.