Important Safety Information
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
SAFETY PRECAUTIONS
WARNING
•
Installation must be performed according to the
installation instructions. Improper installation can cause
water leakage, electrical shock or fire.
•
Use only the included accessories and parts and
specified tools for the installation. Using non-standard
parts can cause water leakage, electrical shock, fire,
injury or property damage.
•
Make sure that the outlet is grounded and has the
appropriate voltage. The power cord is equipped with
a three-prong grounding plug to protect against shock.
Voltage information can be found on the nameplate of
the unit.
•
The unit must be used in a properly grounded wall
receptacle. If the wall receptacle is not adequately
grounded or protected by a time delay fuse or circuit
breaker (the fuse of circuit breaker needed is determined
by the maximum current of the unit. The maximum
current is indicated on the nameplate located on the
unit), have a qualified electrician install the proper
receptacle.
•
Install the unit on a flat, sturdy surface. Failure to do so
could result in damage or excessive noise and vibration.
•
The unit must be kept free from obstruction to ensure
proper function and to mitigate safety hazards.
•
Do not modify the length of the power cord or use an
extension cord to power the unit.
•
Do not share a single outlet with other electrical
appliances. Improper power supply can cause fire or
electrical shock.
•
Do not install the unit in a wet room such as a bathroom
or laundry room. Too much exposure to water can cause
electrical components to short circuit.
•
Do not install the unit in a location that may be exposed
to combustible gas as this could cause fire.
•
The unit has wheels to facilitate moving. Make sure not
to use the wheels on thick carpet or to roll over objects as
this could cause tipping.
•
Do not operate a unit that been dropped or damaged.
•
Do not touch the unit with wet or damp hands or when
barefoot.
•
If the air conditioner is knocked over during use, turn
off the unit and unplug it from the main power supply
immediately. Visually inspect the unit to ensure there
is no damage. If the unit has been damaged contact a
technician or customer service for assistance.
•
In a thunderstorm, the power must be cut off to avoid
damage to the machine due to lightning.
•
•
•
•
CAUTION
•
•
•
•
•
•
•
•
•
•
•
SAVE THESE INSTRUCTIONS!
The unit should be used in such a way that it is protected
from moisture. e.g. condensation, splashed water, etc. Do
not place or store the unit where it can fall or be pulled
into water or any other liquid. Unplug immediately if this
occurs.
All wiring must be performed strictly in accordance with
the wiring diagram location inside the unit.
The units circuit board (PCB) is designed with a fuse to
provide over current protection. The specifications of the
fuse are printed on the circuit board.
When the water drainage function is not in use keep the
upper and lower drain plugs firmly installed in the unit.
The drain plugs can be a choking hazard to children.
This appliance is not intended for use by persons
(including children) whose physical, sensory or mental
capabilities may be different or reduced, or who lack
experience or knowledge, unless such persons receive
supervision or training to operate the appliance by
a person responsible for their safety. Children should
be supervised to ensure that they do not play with the
appliance. Children must be supervised around the unit at
all times.
If the power supply cord is damaged it must be replaced
by the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
Prior to cleaning or other maintenance, the appliance
must be disconnected from the power supply.
Do not run cord under carpeting. Do not cover cord with
throw rugs, runners or similar coverings. Do not route
cord under furniture or appliances. Arrange cords away
from traffic and where it will not be tripped over.
Do not operate a unit with a damaged power cord, plug,
power fuse or circuit breaker. Discard the unit or return
to an authorized service facility for examination and/or
repair.
To reduce the risk of fire or electric shock do not use this
air conditioner with any solid-state speed control device.
The appliance shall be installed in accordance with
national wiring regulations.
Contact the authorized service technician for repair or
maintenance of this unit.
Contact the authorized service installer for installation of
this unit.
Do not cover or obstruct the inlet or outlet grilles.
Do not use this product for functions other than those