Publicidad
Idiomas disponibles
Idiomas disponibles
4 INSTRUMENT DESCRIPTION
4.1 KEYBOARD
LED "STATUS" blinks every time the START/STOP key is pressed.
5 INITIAL SETTINGS
5.1 DATE, TIME AND MEASURING INTERVAL
It's possible to set measuring interval as well as date and time by using the management
software. This program allows to:
Set the Measuring Interval.
Control data and time of the instrument's internal clock.
Set instrument date and time.
Check battery status.
How to operate:
1. Connect the instrument to PC COM using included serial cable.
2. Run TopView software and open the "PC-Instrument Connection" section
3. Perform the detection of the instrument by using the "Find the instrument" or
"Autoset" keys
4. Select the "Configure the instrument" command and press the "Next" key in order to
set date/time in the instrument and the measurement interval in the "Integrated
Period" field selecting values 1s, 6s, 30s, 1min or 5min
5. Confirm with "Send" command
The instrument could keep the data stored even without batteries. The set date
and time don't get lost provided that the battery replacement takes less than 2
minutes.
Fig. 1: Instrument description
CAUTION
EN - 6
XL421 - XL422
CAPTION:
1. Flexible head
2. "STATUS" LED
3. "ALARM" LED
4. RS232 port
5. "START/STOP" key
6. Press here to open
the head
Publicidad
