Publicidad
Idiomas disponibles
Idiomas disponibles
Fig. D
Dual Range Gearing (Fig. E)
The dual range feature of your drill allows you to shift gears
for greater versatility.
1. To select low speed, high torque setting (position 1),
turn tool off and permit to stop. Slide gear shifter button
away from the chuck.
6
2. To select high speed, low torque setting (position 2),
turn tool off and permit to stop. Slide gear shifter button
6
towards the chuck.
NOTE: Do not change gears when tool is running. If you
are having trouble changing gears, make sure that the dual
range gear button is either completely pushed forward or
completely pushed back.
Fig. E
Installing and Removing the
Battery Pack (Fig. A)
NOTE: For best results, make sure your battery pack is
fully charged.
To install the battery pack
battery pack with the rails inside the tool's handle and slide
it into the handle until the battery pack is firmly seated in
the tool and ensure that it does not disengage.
To remove the battery pack from the tool, press the release
button
and firmly pull the battery pack out of the tool
9
handle. Insert it into the charger as described in the charger
section of this manual.
Proper Hand Position (Fig. F)
WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position as shown.
6
8
into the tool handle, align the
WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
sudden reaction.
Proper hand position requires one hand on the main handle
and the other hand holding the battery pack
Fig. F
5
4
OPERATION
WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source remove the battery pack before
making any adjustments or removing/installing
attachments or accessories. An accidental start-up
can cause injury.
Screw Driving
For driving fasteners, the reversing button should be
pushed to the left. Use reverse (button pushed to the right)
for removing fasteners. When moving from forward to
reverse, or vice versa, always release the trigger switch first.
Drilling
WARNING: Drill may stall if overloaded causing a
sudden twist. Always expect the stall. Grip the drill
firmly to control the twisting action and avoid injury.
•
Use sharp drill bits only.
•
Support and secure work properly, as instructed in the
Safety Instructions.
•
Use appropriate and required safety equipment, as
instructed in the Safety Instructions.
•
Secure and maintain work area, as instructed in the
Safety Instructions.
•
Run the drill very slowly, using light pressure, until
the hole is started enough to keep the drill bit from
slipping out.
•
Apply pressure in a straight line with the bit. Use
enough pressure to keep the bit biting but not so much
as to stall the motor or deflect the bit.
•
Hold the drill firmly with two hands, one hand on the
handle, and the other gripping the bottom around the
battery area.
•
Do not click the trigger of a stalled drill off and on in an
attempt to start it. Damage to the drill can result.
•
Minimize stalling on breakthrough by reducing pressure
and slowly drilling through the last part of the hole.
•
Keep the motor running while pulling the bit out of a
drilled hole. This will help reduce jamming.
ENGLISH
4
.
8
29
Publicidad
