Publicidad
Idiomas disponibles
Idiomas disponibles
Pull lid latches in an outward motion and remove tank cover. Remove any accessories and literature that
may have been packed in the vacuum tank.
ATTACHING DOLLY
1. To attach dolly to bottom of tank, lift vacuum using the top handle. Position vacuum above
dolly with the front of the vacuum facing the front of the dolly (side with the release lever).
2. Place tab on back bottom of tank into slot in back of dolly.
3. Push downward on front of vacuum until front of tank clips into lever on dolly.
REMOVING DOLLY
To remove dolly, gently push downward on the release lever with your foot. While holding the
release lever down, lift upwards on vacuum using the top carry handle.
TOOL HOLDER
(Not standard with all models)
If your unit came with a tool holder, assemble as follows:
1. Set tank cover onto the tank. Position with back of tank cover facing you.
2. Take tool holder and place tabs on tool holder into slots on back of tank cover.
3. Press down until tabs snap into place. Remove tank cover from tank and refer to the set
up and operation section.
SET UP AND OPERATION
DANGER
like that tend to produce arcs or sparks that can cause an explosion. Do not pick up flammable,
combustible, or hot materials. Do not use around explosive liquids or vapors, as electrical devices
produce arcs or sparks which can cause a fire or explosion - do not use at filling stations or
anywhere gasoline is stored or dispensed.
1. Refer to the filter installation and maintenance section to make sure the correct filters
are installed for your cleaning operation.
2. Replace tank cover, and apply pressure with thumb to each latch until it snaps tightly
into place. Make certain all lid latches are clamped securely.
3. Install machine hose end into inlet located on the front of the tank.
4. Attach the desired cleaning accessory onto the accessory end of the hose. NOTE: Many
more useful tools are available at your local dealer or the Shop-Vac
5. Plug the cord into the wall outlet. Your cleaner is ready for use.
I = ON, O = OFF
UNPACKING
ASSEMBLY
–
This equipment incorporates parts such as switches, motors or the
website.
®
PAGE 5
Publicidad
