Publicidad
Idiomas disponibles
Idiomas disponibles
MAINTENANCE
Cutting Blades
For the best mowing results, it is important that
blades are correctly sharpened and not damaged.
Replace blades that have been bent or cracked
when hitting obstacles.
Let the service workshop decide if a blade with
large nicks can be repaired/ground or must be
replaced. Balance the blades after sharpening.
Check the blade mounts.
Blade replacement
1. Remove blade bolt by turning counter
clockwise.
2. Install new or resharpened blade with
stamped GRASS SIDE facing towards
ground/grass (down) or THIS SIDE UP facing
deck and cutter housing.
3. Seat the blade's opening firmly onto the cutter
housing.
4. Tighten blade bolt securely.
5. Torque blade bolt to 45-60 ft/lbs (60-81 Nm).
CAUTION! Blades are sharp. Protect
your hands with gloves and/or wind heavy cloth
around the blades before handling.
The sharpening of blades must be
carried out by an authorized service
workshop.
IMPORTANT INFORMATION Special blade
bolt is heat treated. Replace with a Husqvarna
bolt if required. Do not use lower grade
hardware than specified.
Cleaning
Regular cleaning, especially below the mower
deck, will increase the machine's life-span. Make
it a habit to clean the machine directly after use
(after it is cooled), before the debris sticks.
Do not spray water on the top of the mower
deck. Use compressed air to clean the top side
of mower deck. Regularly clean the underside of
the deck with normal water pressure. Do not use
a high pressure washer or steam cleaner. Avoid
spraying engine and electrical components with
water.
For models fitted with a cleanout port, attach the
quick connect (from the accessory packet) to a
garden hose. After mowing, snap the hose to the
cleanout port and turn on water supply.
Restart the mower and engage the blades to use
the spinning action to clean away debris. Make
sure the hose is away from the mower blades.
Do not flush hot surfaces with cold water. Let unit
cool before washing.
CAUTION! Use protective glasses
when cleaning and washing.
Hardware
Check daily. Inspect the entire machine for loose
or missing hardware.
27
Publicidad
