Dometic GROUP Waeco PerfectView CAM60 Instrucciones De Montaje Y Uso página 32

Mounting the camera
If you would like to attach the camera with threaded screws fitted
through the construction (fig. c, page 5)
NOTICE! Risk of damage!
A
Ensure that that nuts cannot be pulled through the body shell when
they are tightened.
Use larger washers or metal plates if necessary.
➤ Drill Ø 6.5 mm holes at the points you have just marked.
➤ Deburr all drill holes and apply rust-protection.
➤ Screw the camera bracket on with the M6 x 20 mm threaded screws.
Depending on the thickness of the construction, you may require longer
threaded screws.
Creating a through-hole for the camera connection cable
(fig. d, page 5)
NOTE
I
If possible, use available openings – such as ventilation grilles – to
feed the connection cables through. If there are no existing open-
ings, you must drill a hole with a 16 mm diameter.
NOTICE! Risk of damage!
A
Ensure that there is sufficient space on the other side for the drill
head to come out
➤ Drill a hole of Ø 16 mm near the camera.
➤ Deburr all drill holes that have been made in the sheet metal and apply
rust-protection.
➤ Place cable sleeves in all sharp edged ducts.
Mounting the camera
NOTICE! Risk of damage!
A
Only use the screws supplied to mount the camera in the camera
bracket. Longer screws will damage the camera.
➤ Push the camera into the camera bracket.
➤ Attach the camera loosely with the two screws M3 x 10 mm in the slots
(fig. e, page 5).
32
PerfectView CAM60
EN