Camp4 706629 Manual Del Usuario página 9

CAMP4 l Gas Grill Stove Gourmet BBQ | 706629
IMPORTANT
• Read these instructions for use carefully so as to familiarize yourself with the appliance before
connecting it to its gas cartridge.
• Keep these instruction for future reference.
• This appliance shall only be used with CRV butane cartridge.
It may be hazardous to attempt to fit other types of gas cartridges.
• Don't use appliances when ambient temperature is higher than 35°C.
• Don't use appliances when the cover of cartridge enclosure is in open position.
• Release or disconnect the gas cartridge after every use.
• This appliance should only be used in well-ventilated areas away from inflammable materials.
• Keep young children away from the appliance.
WARNING
DO NOT place a grill plate on burner without grill support assemby (7).
NEVER use other cooking vessel.
Check that seals (between the appliance and the gas cartridge) are in place and in good condition
before connecting the gas cartridge (fig.6).
Don't use the appliance if it has damaged or worn seals.
CAUTION: accessible parts may become very hot, Keep children away from the appliance
SAFETY DEVICE
• The appliance is equipped with a safety device which stops the flow of gas if the pressure in the
cartridge, e.g. because of overheating, becomes too high.
USING THE STOVE FOR THE FIRST TIME
1. Check that the control knob (8) is set to position "•" by turning it clockwise and the cartridge lever
(6) is set to UNLOCK.
2. Open the cartridge cover (2) and insert the cartridge, with the head to the front, so the notch points
upwards and aligns in the value guide (fig.2).
3. Press the cartridge lever (6) down (fig.3) and close the cartridge cover.
4. If you hear a "hissing" noise, the cartridge has not been correctly fitted. Do not attempt to ignite the
appliance but move lever (6) to the "Unlock" position and repeat step (1-4).
5. Turn the knob (8) fully to the ignition position until it clicks (fig.4). Hold the ignition & control knob
in this position for a few seconds to prime the flame guard thermocouple. Repeat this action until
burner ignites.
6. Adjust the control knob to the required position. (fig.5) Never set the cartridge lever (6) to the
"UNLOCK" position during use!
To continue usage:
• Turn the control knob to "•" position.
• Turn the cartridge lever to "UNLOCK" position and take the cartridge out.
• Turn the control knob to the ignition position to release any excess pressure
inside the valve.
• Push down the reset lever with red rubber cap.
• Place new cartridge after checking that the cartridge lever is in "UNLOCK"
position. (If new cartridge is not hand, cool down the cartridge in use with water.)
• The cartridge can only be installed when the control knob is in the
"•"-position
9
DE
EN
IT
ES
FR
NL
FI
DK
SE
Reset lever