Create Board Scale Bamboo Manual De Instrucciones página 7

HOW TO USE THE SCALE
1. Put the scale on a hard and flat surface.
2. Place a bowl (if needed) on the scale before turning on the unit.
3. Press and release the ON/ZERO button to turn on the unit.
4. Wait until the display shows "0g" before starting weighing.
HOW TO CHANGE WEIGHT UNITS
• Once the scale is on, press the button "UNIT" to toggle between "g" and "oz".
• You can do it with ir without load on the scale.
ZERO AND TARE FUNCTION
• To weigh different loads consecutively without removing loads from the scale, put first
load on the scale and get weight reading.
• Press ON/ZERO button to reset the LCD reading to 0 before adding next load.
• Repeat this operation as many times as you need.
There are two procedures:
ZERO function:
1. The LCD screen will show "0g" each time ON/ZERO is pressed.
2. A number 0 will be shown on the lower right corner of the screen, indicating that the
ZERO function is active.
3. Max. capacity remains unchanged every time ON/ZERO is pressed.
TARE function:
1. The LCD screen will show "0g" each time ON/ZERO is pressed.
2. The icon TARE will be shown on the lower left corner of the screen, indicating that the
TARE function is active.
3. Max. capacity is reduced by the total weigh of all loads.
WARNING: When the scale is overloaded, the LCD screen will show EEEE. Take off the load
so as not to damage the product.
OPERATING INSTRUCTIONS
E NGLI SH
7