auronic AU3228 Manual De Instrucciones página 32

For safety reasons, the product will automatically shut down when the temperature reaches
•
±36°C in the room where the product is placed.
Due to circulation of the coolant, the product may make noise when starting up. When the
•
circulation is stable, the noise will decrease.
4. TROUBLESHOOTING
If the following problems occur while using the product, refer to the table below to find a
solution. If the problems cannot be solved using these options, please contact our customer
service.
Problem
The product is not
working.
The product does not
dehumidify properly.
32
Cause
The plug is not plugged
in.
The collection tray is
full.
The collection tray
is not correctly
positioned.
The air vents are
blocked.
The product is
defrosting.
The air vents are dirty.
The air vents are
blocked.
The product is not in
dehumidifying mode.
The temperature in the
room is too low.
The humidity in the
room is too low.
The room is too large.
Solution
Make sure the plug is plugged in correctly.
Make sure the collection tray is empty.
Make sure the collection tray is correctly
placed in the product.
Make sure there is enough space around
the product. Make sure the air vents are
not blocked.
This is normal. See "Instructions for use >
Notes".
Clean the air vents regularly as described
under "Maintenance and cleaning".
Provide adequate space around the
product. Make sure the air vents are not
blocked.
Touch the position knob repeatedly so that
the dehumidify mode is selected.
This is normal. The product stops when the
temperature is below 5°C.
This is normal. The product stops when the
humidity is below 60% and is in automatic
mode.
Make sure all windows and doors are
closed and that the room does not exceed
the capacity of the product.