Crosley Professional YFD45 Manual De Instrucciones página 12

REVERSING THE DOOR SWING (if desired)
REMOVE THE DOOR ASSEMBLY
1
A. Open the door to approximately 130 degrees .
B. Remove the 6 tapping screws located around
the perimeter of the door outlining the gasket .
Remove the outer ring .
C. Remove 3 hinge screws starting at the
bottom and move up . Make sure the door is
supported while removing the screws .
D. Loosen the top screw as shown . Unhook the door
by lifting and pulling . Remove the top screw .
12
Optional Instructions
Then loosen top
screw, remove door
and remove screw
First remove
three lower
hinge screws
2 REMOVE HINGE AND COVER
IMPORTANT: Note the location of the hinge (left
or right) before removing .
A. Remove the 6 machine screws from the hinge
and the 2 machine screws from the hinge cover .
Hinge
B. With the screws removed, turn the door over
and separate the outer door assembly and hinge
cover of the door from the door frame and set
aside .
Hinge
REINSTALL HINGE ASSEMBLY
3
A. Place the hinge in the opposite side of the
door as shown . Push the hinge in place until
the hinge holes align with the door holes .
Hinge
Cover
Hinge
Cover
Hinge shown
on opposite
side
49-3000063