Publicidad
Idiomas disponibles
Idiomas disponibles
2. Installation of the chimney supports (first section)
The chimney of the extractor hood is made up of two pieces, which are
inserted one inside the other to adapt to the height between the ceiling and
the main body of the extractor hood.
a) Position the first chimney section (the one without vents) so that the
screw holes are at the bottom.
b) Insert support A into the interior of the fireplace, matching the tabs on
the support with the slots on the inside of the fireplace.
c) Mark the two holes B of the chimney bracket.
d) Drill two 10 mm Ø holes at marks B.
e) Insert the supplied plugs C.
f)
Attach the bracket and fix it to the wall using the supplied screws D.
11
Publicidad
