Descargar Imprimir esta página

Intec I-STARTER XL Manual Del Usuario página 12

Arrancador de emergencia litio 12/24v

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

English
WARNING
1.
PRIOR TO USE, READ AND UNDERSTAND PRODUCT SAFETY INFORMATION.
Failure to follow the instructions may result in EXPLOSION OR FIRE
which may result in serious injury, death and damage to device or
property.
2.
The product is an emergency starter for vehicles with 12V or 24V battery,
starting other types of vehicles can be dangerous.
3.
DO NOT use in place of vehicle battery.
4.
The product is not a toy, keep out of reach of children, do not use it if children
are close to the vehicle.
5.
Wear eye protection and gloves when operating product. Batteries can
explode and cause flying debris. Battery acid is very dangerous for eyes and
skin. In the case of contamination flush affected area with running clean
water and contact poison control immediately.
6.
The jump starter should only be recharged by means of the through the
supplied charger.
7.
Carefully check the battery polarity before to connect the clamps, DO NOT
short circuit the clamps
8.
Black clamp must be connected to a proper vehicle mass, DO NOT connect to
carburetor, gasoline hoses or thin metal parts.
9.
Wait at least two minutes before following jump start if the first one has
not been successful. After 8 attempts in a row you must stop for at least 10
minutes to allow the internal heat dissipate.
10. After successfully starting the vehicle remove the clamps from the battery
before 30 seconds.
11. DO NOT store in locations where the temperature may exceed 60°C, charge
the product only between 0°C and 45°C in well ventilated areas and at proper
distance from flammable materials.
12. DO NOT expose the product to rain or water.
12

Publicidad

loading

Productos relacionados para Intec I-STARTER XL