Makita UB002CZ01 Manual De Instrucciones página 14

Accidental re-start preventive
function
When you turn on the machine while pulling the switch
trigger, the machine does not start and the main power
lamp blinks in green. To start the machine, first release
the switch trigger and return the control lever fully, and
then turn on the machine.
OPERATION
CAUTION:
When putting on the machine, be
sure to put shoulder harness on your both shoul-
ders. Otherwise, the machine may fall when you put
on or use the machine, and cause an injury.
CAUTION:
When putting on the machine,
be sure to put on the machine on your back.
Otherwise, the machine may fall during operation and
cause an injury.
CAUTION:
Do not place the machine on the
ground while it is running. Sand or dust may enter
from suction inlet and cause a malfunction or per-
sonal injury.
1.
Press the power button on the portable power
pack. The main power lamp will light up.
► Fig.24: 1. Power button 2. Main power lamp
2. Put on the shoulder harness of the machine and
lock the buckle on the waist belt.
3. Press the main power switch to turn on the
machine.
The machine is ready to operate. The machine will run
when you pull the switch trigger.
► Fig.25: 1. Main power switch
Hold the control handle firmly and perform the blowing
operation by moving it around slowly. When blowing
around building, big stone or vehicle, direct the nozzle
away from them. When performing an operation in a
corner, start from the corner and then move to wide
area.
► Fig.26
When setting down the machine, unlock the buckle of
the waist belt, and then set down the machine slowly.
► Fig.27: 1. Buckle
MAINTENANCE
CAUTION:
Always be sure that the machine is
switched off and the battery cartridge is removed
before attempting to perform inspection or
maintenance.
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
Cleaning the machine
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
Clean the machine by wiping off dust with a dry cloth or
one dipped in soapy water and wrung out.
Remove dust or dirt from the suction inlet.
► Fig.28: 1. Suction inlet
Storage
NOTICE:
Be sure to close the plug cover before
storage. If the plug cover is opened or not fully
closed, dust may enter the machine and cause a
malfunction of machine.
Before storing the machine, pull out the socket from the
plug and perform full maintenance. Store the machine
in a place out of the reach of children and not exposed
to moisture, rain, or direct sunlight.
You can connect the band of the pipe to the machine as
shown in the figure to stand up the pipe.
► Fig.29: 1. Socket 2. Plug cover 3. Band
14 ENGLISH