Publicidad
Idiomas disponibles
Idiomas disponibles
Fault
The hair is singed.
Error message E01
or E04–E10 shows in
the display.
Error message E02
or E03 shows in the
display.
8
Technical data
Model:
Voltage:
Power:
Max. motor speed:
Max. air speed:
Temperature settings:
Noise level:
Weight:
9
FCC statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
Warning: Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Possible cause and solution
• The selected operating temperature is too high. Select a lower
temperature.
• There is an internal error. Contact customer service for
support.
• The voltage is either too low or too high. Connect the
product to an appropriate power outlet.
HCA02NA
125 V~, 50/60 Hz
1,300 W
105,000 rpm (± 5,000)
42.7 ft/s / 13 m/s (2.4 inches/6 cm)
39, 50, 70 or 90 °C (102, 122, 158 or 194 °F)
≤ 80 dB (11.8 inches/30 cm) (without attachment)
19.4 oz (550 g) (including ALCI plug)
EN
12
Publicidad
