Publicidad
Idiomas disponibles
Idiomas disponibles
SERVICING OF DOUBLE-INSULATED APPLIANCES
In a double-insulated appliance, two systems of insulation are provided instead of
grounding. No grounding means is provided on a double-insulated appliance, nor should
a means for grounding be added to the appliance. Servicing a double-insulated appli-
ance requires extreme care and knowledge of the system, and should be done only by
qualified service personnel. Replacement parts for a double-insulated appliance must be
identical to the parts they replace. A double-insulated appliance is marked with the words
"DOUBLE INSULATION" or "DOUBLE INSULATED". The symbol ( square within a
square) may also be marked on the appliance.
2
OPERATING INSTRUCTIONS
This appliance has a polarized plug (one blade is wider than the other). As a safety
feature, this plug will fit in a polarized outlet only one way. If the plug does not fit fully in
the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Do not
attempt to defeat this safety feature.
2.1 ALCI SAFETY DEVICE
This appliance is provided with a protective device that may make the
appliance inoperable under some abnormal conditions. If the appliance
becomes inoperable, discard the appliance or return the appliance to a
RESET
service center for examination and repair.
TEST
ALCI (Appliance Leakage Current Interrupter) SAFETY DEVICE: This
device provides protection against electric shock due to ground fault
currents by automatically shutting off the power.
The TEST and RESET buttons on the ALCI plug are used to check if the device is func-
tioning properly. It is recommended to check the device monthly. To do so:
1. Press the TEST button.
2. The RESET button should pop up. If not, do not use the product.
3. Press the RESET button to restore power.
If the TEST button is pressed and the product can still be turned on, current leakage has
been detected. Do not use the product or attempt to reset the ALCI safety device.
WARNING:
• DO NOT press the TEST button while the product is operating.
• The TEST and RESET buttons should not be used as "ON" and "OFF" switches.
• The cord and plug are not intended to offer protection to externally connected loads
or supply circuits.
• The cord and plug are intended for indoor use only.
EN
6
Publicidad
