Husqvarna 520iLX Manual Del Usuario página 11

Safety instructions for maintenance
WARNING:
instructions that follow before you do
maintenance on the product.
• Remove the battery before you do maintenance,
other checks or assemble the product.
• The operator must only do the maintenance and
servicing shown in this operator's manual. Turn to
your servicing dealer for maintenance and servicing
of a larger extension.
• Do not clean the battery or the battery charger with
water. Strong detergent can cause damage to the
plastic.
• If you do not do maintenance, it decreases the
life cycle of the product and increases the risk of
accidents.
Introduction
This section describes how to assemble and adjust the
product.
WARNING:
product, read the safety chapter and the
assembly instructions.
To assemble the loop handle
1. Attach the loop handle onto the shaft between the
arrows.
2. Move the spacer into the slot of the loop handle.
Introduction
WARNING:
safety chapter before you use the product.
756 - 012 - 15.02.2024
Read the warning
Assembly
Before you assemble the
Operation
Read and understand the
• Special training is necessary for all servicing and
repair work, especially for the safety devices on the
product. If not all checks in this operator's manual
are approved after you have done maintenance, turn
to your servicing dealer. We guarantee that there are
professional repairs and servicing available for your
product.
• Only use original spare parts.
• Maintenance, replacement, or repair of the emission
control devices and system may be performed
by any nonroad engine repair establishment or
individual.
SAVE THESE
INSTRUCTIONS
3. Install the nut, the knob and the screw. Do not
tighten too much.
4. Adjust the product to an applicable position.
5. Tighten the bolt.
To assemble the trimmer guard
1. Install the correct trimmer guard for the trimmer
Accessories on page 19 .
head, refer to
2. Hang the trimmer guard on the hook on the plate
holder (A).
3. Bend the trimmer guard around the shaft and attach
it with the bolt (B) on the opposite side of the shaft.
A
Before you operate the product
• Examine the work area to make sure that you know
the type of terrain. Examine the slope of the ground
and if there are obstacles such as stones, branches
and ditches.
• Do a general inspection of the product.
B
11