Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING INSTRUCTIONS
POWER SUPPLY
Your nail grinder comes with a power adapter. Plug cord from nail grinder into
adapter, then plug power supply into electrical outlet. Operate at 120 volt,
60 cycle AC electrical current or as noted on unit.
ASSEMBLING NAIL GRINDER
Your Andis nail grinder comes with two sizes of sanding drums and sanding bands:
1/4" and 1/2".
To remove a sanding drum: depress collet release button while turning collet nut
counter-clockwise using wrench provided until loose. Remove sanding drum.
To insert a new sanding drum: insert the sanding drum into the collet. Depress
collet release button while turning collet nut clockwise until it locks into place.
Using wrench provided, turn collet nut clockwise until sanding drum is tight.
To replace a sanding band: loosen the screw (using the small screwdriver tip on
the wrench provided) to contract the drum and slide the old band off. Slide the new
sanding band on, and expand the drum by tightening the screw again.
IMPORTANT: Before each use, check that the drum is sufficiently expanded to
secure the band during use. If band is loose during operation, it may be thrown
from grinder and cause injury.
BEFORE GRINDING
Before grinding the animal's nails:
1. Get the animal used to having his paws touched and handled before showing
him the nail grinder. Take a few minutes to manipulate his paws while giving him
positive reinforcement.
2. Let him sniff the nail grinder while it is turned off.
3. Turn the grinder on so he can get used to the sound it makes. Have him sit while
the tool is in your hand and running.
4. Once the animal is used to the tool, try touching it to his nails. Do not do any
actual grinding yet.
5. You may need to repeat the above steps a few times.
5
Publicidad
