Sharp BK-RS08EB Guia De Inicio Rapido página 9

STEP 8: Install the pedals
a. Use the 15 mm wrench to mount the pedals, as shown in Figure 8-1.
L
R
NOTES:
Check the end cap on both pedals to identify the left pedal and right pedal.
Please note that the right pedal will tighten clockwise, while the left pedal will
tighten counterclockwise.
Make sure the torque is 18 N·m.
STEP 9: Install the lights, reflector, etc.
a. Mount the front light on the handelbar, as shown in Figure 9-1.
b. Mount the tail ight on the saddle pipe, as shown in Figure 9-2.
c. Mount the front reflector and bell on the handlebar, as shown in Figure
9-3.
8
Figure 7-2
Figure 8-1
STEP 10: Install the kickstand
a. Loosen screws and washers and then remove them from the dropout,
as shown in Figure 10-1.
b. Use a 5 mm Allen key to mount the kickstand onto the dropout, and
retighten the screws to the torque of 10-12 N·m.
Figure 9-1
Figure 9-2
Figure 9-3
7
Figure 10-1
EN