Publicidad
Idiomas disponibles
Idiomas disponibles
The eyeshades
Each eyepiece has its rubber eyeshade. This prevents damage to the lens, and prevents stray light. The eyeshade can
simply be slipped over the eyepiece
Connecting the power adapter
The EduBlue series stereomicroscopes supported a wide range of operating voltages: from 100 to 240V. Please use a
grounded power connection
1.
Make sure the power switch is off before connecting
2.
Insert the plug of the adapter into the EduBlue power socket, and make sure it connects well
3.
Insert the other connector into the mains socket, and make sure it connects well
Do not bend or twist the power cord from the adapter, it will get damaged. Use the power adapter that is supplied by
Euromex. If it's lost or damaged, choose one with the same specifications
Operation
Insert the plug of the power supply adapter into the mains supply and switch on the illumination with the On/off
switch (L) and place the eyeshades onto the eyepieces. Place a sample on the object plate, sit comfortably down
behind the stereomicroscope and take a relaxed position while viewing through the eyepieces (A)
Eyepieces
In order to obtain a smooth "compound" image, we recommend you to go through the below steps
1. The interpupillary distance
The correct interpupillary distance is reached when one round image is seen in the field of view (see image below).
This distance can be set by either pulling the tubes towards each other or pulling them away from each other.
This distance is different for each observer and thus should be set individually. When more users are working with
the stereomicroscope it is recommended to remember your interpupillary distance for a quick set up during new
microscopy sessions
8
8
EN
Field of view
before adjustment
Field of view
after adjustment
Publicidad
