Buffalo 600 Serie Manual De Instrucciones página 4

EN
Introduction
Please take a few moments to carefully read through this manual. Correct maintenance and operation of
this machine will provide the best possible performance from your Buffalo product.
Before initial use of the appliance, the outer surface should be wiped with a cloth soaked in warm water
and soap.
Buffalo will not accept liability for product failures in the event that:
• The instructions in this manual have not been followed correctly.
• Unqualified or unauthorized personnel have adjusted the appliance.
• Non-original spare parts are used.
• The appliance has not been handled and cleaned correctly.
• The appliance has been used for a purpose for which it was not intended.
• The appliance is used by personnel not trained or unfamiliar with the usage of the unit.
Pack Contents
The following is included:
• BUFFALO under counter convection oven
• Oven wire shelf (x1)
BUFFALO prides itself on quality and service, ensuring that at the time of unpacking the contents are
supplied fully functional and free of damage.
Should you find any damage as a result of transit, please contact your BUFFALO dealer immediately.
Installation
Warning: Incorrect installation, operation, maintenance or cleaning of the
equipment, as well as any modification can cause property damage and personal
casualty. Fully read and understand all instructions before installation.
Before installation and operation, it is the user's responsibility to ensure that all
Health & Safety regulations concerning safe positioning, spacing, ventilation,
electrical installation, and fire risk, are complied with.
• Remove the appliance from the packaging, ensuring that all protective packaging, plastic and residues
are thoroughly cleaned from its surfaces.
• Place the unit on a solid, level and heat-resistant surface. Avoid placing it on or close to flammable
materials. Maintain a distance of 20cm (7 inches) between the appliance and walls or other objects
for ventilation.
• Keep the unit away from splashing water and countertop's edge.
To install a Buffalo 600 series appliance on top of the oven:
1. Remove oven upper perforated sheet.
2. Remove the back sheet of the oven.
3. Place the Buffalo 600 series appliance on top of the oven (no need to remove the legs).
4. Fix the appliance and oven together and attach with the M5 bolt screws provided.
5. Re-attach the back sheet of the oven.
4
CU470_ML_A5_v2_20240202.indb 4 CU470_ML_A5_v2_20240202.indb 4
• Instruction manual
2024/2/2 14:12 2024/2/2 14:12