D.A.S. H serie Manual De Usuario página 19

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

APPENDIX A. Bridge Mode Operation
To operate in bridge mode, follow these steps:
1.
Switch off the amplifier.
2.
Turn volume control potentiometers on the front panel to minimum position (fully anticlockwise).
3.
Connect input signal to channel A.
4.
Set mode switch to
5.
Connect speakers as follows:
Connect (+) to red speaker terminal on channel A's output terminals
Connect (-) to red speaker terminal on channel B's output terminals
6. Turn volume control potentiometers on the front panel to maximum position (fully clockwise).
7. Control volume levels from the mixer or pre-amp only.
NOTE: We do not recommend using bridge mode with loads lower than 4 ohms
H series
Serie H /
"BRIDGE"
.
Manual del usuario /
User's manual
15

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

H-3000H-1500H-2200H-4000H serie

Tabla de contenido