Buffalo 600 Serie Manual De Instrucciones página 4

EN
Introduction
Please take a few moments to carefully read through this manual. Correct maintenance and operation of
this machine will provide the best possible performance from your Buffalo product.
Buffalo will not accept liability for product failures in the event that:
• The instructions in this manual have not been followed correctly.
• Unqualified or unauthorized personnel have adjusted the appliance.
• Non-original spare parts are used.
• The appliance has not been handled and cleaned correctly.
• The appliance has been used for a purpose for which it was not intended.
• The appliance is used by personnel not trained or unfamiliar with the usage of the unit.
Pack Contents
The following is included:
• BUFFALO boiling top
BUFFALO prides itself on quality and service, ensuring that at the time of unpacking the contents are
supplied fully functional and free of damage.
Should you find any damage as a result of transit, please contact your BUFFALO dealer immediately.
Installation
Warning: Incorrect installation, operation, maintenance or cleaning of the
equipment, as well as any modification can cause property damage and personal
casualty. Fully read and understand all instructions before installation.
Before installation and operation, it is the user's responsibility to ensure that all
Health & Safety regulations concerning safe positioning, spacing, ventilation,
electrical installation, and fire risk, are complied with.
• Remove the appliance from the packaging, ensuring that all protective packaging, plastic and residues
are thoroughly cleaned from its surfaces.
• Place the unit on a heat-resistant surface (Or boiling top stand if purchased). Avoid placing it on or
close to flammable materials. Maintain a distance of 20cm (7 inches) between the appliance and walls
or other objects for ventilation.
• Keep the unit away from splashing water and countertop's edge.
Electrical wiring
There is a danger to life if the wires are incorrectly connected.
Connection to a suitable power supply should only be carried out by a qualified and
competent electrical engineer.
Warning: The fixed wiring of the power cord connection must be equipped with a
disconnect device (leakage protection switch) with a contact distance greater than 30mm
according to the wiring rules.
Connect the unit in accordance with the applicable regulations of your country, federal state, city or local
authority.
Connect the unit to a standard energy supply network.
For a proper electrical connection, adjust the power ratings to the local circumstances and requirements.
Equipotential bonding terminal in electrical appliances is to connect exposed metal and conductive
4
CU471_CU472_ML_A5_v2_20240202.indb 4 CU471_CU472_ML_A5_v2_20240202.indb 4
DANGER of electric shock from incorrect connection
• Instruction manual
2024/2/2 11:16 2024/2/2 11:16