Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION STEP 13
ELECTRICAL REQUIREMENTS
To avoid installation difficulties, do not run the opener at this time.
To reduce the risk of electric shock, your garage door opener has a grounding type
plug with a third grounding pin. This plug will only fit into a grounding type outlet.
If the plug doesn't fit into the outlet you have, contact a qualified electrician to
install the proper outlet.
RIGHT
If permanent wiring is required by your local code, refer to the following
procedure. To make a permanent connection through the 7/8 inch hole in the top
of the motor unit (according to local code):
1. Remove the motor unit cover screws and set the cover aside.
2. Remove the attached 3-prong cord.
3. Connect the black (line) wire to the screw on the brass terminal; the
white (neutral) wire to the screw on the silver terminal; and the ground
wire to the green ground screw. The opener must be grounded.
4. Reinstall the cover.
WRONG
To prevent possible SERIOUS INJURY or DEATH from electrocution or fire:
Be sure power is NOT connected to the opener, and disconnect power to
l
circuit BEFORE removing cover to establish permanent wiring connection.
Garage door installation and wiring MUST be in compliance with ALL local
l
electrical and building codes.
NEVER use an extension cord, 2-wire adapter, or change plug in ANY way to
l
make it fit outlet. Be sure the opener is grounded.
PERMANENT WIRING
CONNECTION
Ground Tab
Green
Ground Screw
Ground Wire
27
Black
Wire
Black Wire
White Wire
Publicidad
