Craftsman CMXEOCG471 Manual Del Propietário página 33

OPERATION
To reduce the risk of SEVERE INJURY or DEATH:
1. READ AND FOLLOW ALL WARNINGS AND INSTRUCTIONS.
2. ALWAYS keep remote controls out of reach of children. NEVER permit children
to operate or play with garage door control push buttons or remote controls.
3. ONLY activate garage door when it can be seen clearly, it is properly
adjusted, and there are no obstructions to door travel.
4. ALWAYS keep garage door in sight and away from people and objects until
completely closed. NO ONE SHOULD CROSS THE PATH OF THE MOVING DOOR.
5. NO ONE SHOULD GO UNDER A STOPPED, PARTIALLY OPENED DOOR.
6. If possible, use emergency release handle to disengage trolley ONLY when
garage door is CLOSED. Use caution when using this release with the door
open. Weak or broken springs or unbalanced door could result in an open
door falling rapidly and/or unexpectedly and increasing the risk of SEVERE
INJURY or DEATH.
7. NEVER use emergency release handle unless garage doorway is clear of
persons and obstructions.
8. NEVER use handle to pull garage door open or closed. If rope knot becomes
untied, you could fall.
FEATURES
Your garage door opener is equipped with features to provide you with greater
control over your garage door operation.
REMOTE CONTROLS AND DOOR CONTROLS
Your garage door opener has already been programmed at the factory to operate
with your remote control, which changes with each use, randomly accessing over
100 billion new codes.
Accessories MEMORY CAPACITY
Remote Controls
Up to 8
Door Controls
Up to 2 door controls
Keyless Entries
Up to 1
THE SAFETY REVERSAL SYSTEM
When properly connected and aligned, the safety reversing sensors will detect an
obstruction in the path of the infrared beam. If an obstruction breaks the infrared
beam while the door is closing, the door will stop and reverse to full open
position, and the opener lights will flash 10 times. If the door is fully open, and
the safety reversing sensors are not installed, or are misaligned, the door will not
close from a remote control. However, you can close the door if you hold the
button on the door control or keyless entry until the door is fully closed. The safety
reversing sensors do not effect the opening cycle.
IMPORTANT SAFETY INSTRUCTIONS
9. After ANY adjustments are made, the safety reversal system MUST be
tested.
10. Safety reversal system MUST be tested every month. Garage door MUST
reverse on contact with 1-1/2" (3.8 cm) high object (or a 2x4 laid flat)
on the floor. Failure to adjust the garage door opener properly
increases the risk of SEVERE INJURY or DEATH.
11. ALWAYS KEEP GARAGE DOOR PROPERLY BALANCED (see page 3). An
improperly balanced door may NOT reverse when required and could
result in SEVERE INJURY or DEATH.
12. ALL repairs to cables, spring assemblies and other hardware, ALL of
which are under EXTREME tension, MUST be made by a trained door
systems technician.
13. ALWAYS disconnect electric power to garage door opener BEFORE
making ANY repairs or removing covers.
14. This operator system is equipped with an unattended operation
feature. The door could move unexpectedly. NO ONE SHOULD CROSS
THE PATH OF THE MOVING DOOR.
15. DO NOT install on a one-piece door if using devices or features
providing unattended close. Unattended devices and features are to be
used ONLY with sectional doors.
16. SAVE THESE INSTRUCTIONS.
ENERGY CONSERVATION
For energy efficiency the garage door opener will enter sleep mode when the door
is fully closed. The sleep mode shuts the garage door opener down until activated.
The sleep mode is sequenced with the garage door opener light bulb; as the light
bulb turns off the sensor LEDs will turn off and whenever the garage door opener
lights turn on the sensor LEDs will light. The garage door opener will not go into
the sleep mode until the garage door opener has completed 5 cycles upon power
up.
LIGHTS
The garage door opener light bulbs will turn on when the opener is initially plugged
in; power is restored after interruption, or when the garage door opener is
activated. The lights will turn off automatically after 4-1/2 minutes. An
incandescent A19 light bulb (100 watt maximum) or for maximum energy efficiency
a 26W (100W equivalent) compact fluorescent light (CFL) bulb may be used.
33