Publicidad
Idiomas disponibles
Idiomas disponibles
NOTICE!
Possible material damage!
There is a risk of damage to the appliance if
installed incorrectly.
Place the microwave on a level, stable
surface which is able to carry the weight
of the appliance as well as the maximum
weight of the food which will be cooked
in it.
Use the appliance indoors only.
Do not place the microwave:
– near sources of heat or naked flames
– near radios or televisions
– in the immediate vicinity of inflamma-
ble materials
– in a location prone to wetness or high
humidity.
– in a location with extremely high or
low temperatures or in direct sunlight.
Chemical additives in furniture coatings may
corrode the material of the appliance feet
and cause residue on the furniture surface.
Place the appliance on a heat-resistant
mat if necessary.
Connect the microwave to a convenient
and easily accessible, earthed mains so-
cket.
6.2. Cleaning the appliance
for the fi rst time
Pull the door catch (10) to open the mic-
rowave door.
To remove dust residue from the packa-
ging and any other potential residue
stemming from the manufacturing pro-
cess, wipe out the cooking area (1) and
the inner side of the viewing window (11)
with a slightly damp, soft cloth before
using the appliance for the first time.
Ensure that no liquids penetrate into the
microwave oven and dry the surfaces
completely afterwards.
Clean the glass turntable (6) and the
roller ring (7) in warm water with a little
washing up liquid before drying off these
parts completely.
6.3. Inserting the glass turn-
table
Abb. 3 – Inserting the glass turntable
Do not use the microwave without pro-
perly installing the glass turntable (6).
Check that the drive shaft (8) is correctly
inserted in the recess on the base of the
cooking compartment and that its wings
rest flat on the base. If necessary, turn the
drive shaft (8) until it sinks into its correct
position.
Place the roller ring (7) in the recess in the
cooking area and then place the glass
turntable (6) centrally on the drive shaft
(8) (see „Abb. 3 – Inserting the glass
turntable") so that the webs of the glass
turntable (6) lie between the wings of the
drive shaft.
DE
FR
6
NL
7
ES
8
IT
EN
85
Publicidad
