Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLE MOTOR UNIT ON FRAME
1.
Remove the motor and motor mount assembly from the box.
2. Insert the round steel mounting post in the motor mount into the hole
in the upright support, as shown in the illustration to the right.
Make sure the round mounting post is fully inserted in the hole of the
upright support.
3. Secure the round steel post with the hex head bolt (2%" long, 3/8"
diameter) and washers supplied.
4. Secure the motor unit to the vertical adjustment bracket, using the bolt
eae
ieee
at
and washer with the largest plastic knob in the parts kit. (Part 1031).
MOTOR UNIT INSTALLATION DIAGRAM
PRADE & BLADE GUARD
INSTALLATION
|
The blade guard (2) must be installed before the diamond cutting blade (3) :
can be attached. (See Diagram)
2.
Use the blade guard adjustment knob (1) to fasten the blade guard firmly |
against the motor assembly.
|
3.
Carefully raise the cutting head to its highest position and tighten the .
adjustment knob on the rear support post so the cutting head is held firmly -
in place.
4. Raise the blade Suar to the highest level and tighten the blade guard |
adjustment knob. Then, remove the blade shaft nut and outer flange.
5.
Place the blade onto the shaft, pushing it up against the inner flange. It is
important to be sure the directional arrow is pointing in the direction of `
|
rotation.
BLADE INSTALLATION DIAGRAM |
6. Replace the outer flange and blade shaft nut. With one hand, hold the blade and tighten the blade shaft nut with your
free hand. Make certain the nut is firmly tightened with wrench provided. DO NOT OVER-TIGHTEN!
Release the blade shaft lock after the blade shaft nut is fully tightened.
8.
Lower the blade guard into position and tighten the adjustment knob. Then, slightly loosen the rear support
adjustment knob and lower the cutting head so that the blade is 4" below the top surface of the cutting table. Tighten
the adjustment knob firmly to hold the cutting head in place.
WARNING: SETTING THE BLADE TOO LOW MAY CAUSE DAMAGE TO THE CUTTING TABLE. IF THE BLADE IS SET TOO HIGH,
IT MAY CATCH OR GRAB THE MATERIAL BEING CUT, CAUSING DAMAGE AND POSSIBLE INJURY.
CUTTING TABLE & OPTIONAL CUTTING TABLE EXTENSION
CUTTING TABLE IS MARKED IN INCHES AND CENTIMETERS FOR
ACCURATE CUT DIMENSIONS.
|
CUTTING TABLE
EXTENSION
STEPS FOR POSITIONING 45° RIP GUIDE:
1. Set the rip guide by positioning it on the desired dimension and tighten the threaded
knob on the rip guide. Make sure rip guide is firmly tightened to avoid slippage.
2. The cutting table is notched at the front center position, and 45° table lines are cut
into the table to facilitate quick 45° rip cuts.
3.
Set the corner of the tile into the notch, and line up the tile edges with the 45° table
lines to make your cut.
CUTTING TABLE
4.
For greater stability when cutting larger tiles, use the optional cutting-table extension.
This extension snaps easily onto the leading edge of the cutting table.
|
5. Always move the rear support post back to the 14" position before attempting to use the extension or to cut tiles 14"
or larger (see CUTTING HEAD POSITIONING on next page).
NOTE: IF THE CUT IS SLIGHTLY OFF CENTER, ADJUST THE (4) SAW-FRAME SCREWS. (See WATER TRAY
INSTALLATION on the next page)
oe
A
arde
Zel
ZO
AN md
ri
Kies
A
SAR
Publicidad
