Sears Kenmore Elite 66513852K601 Instrucciones De Instalación página 14

Connect to drain
1. To heHp minimize
vibration, route drain
hose to avoid contact
with motor, door springs,
water Hine, cabinet,
flooring or the edge of
the hoHe where it passes
through the cabinet.
2. Do not remove drain
Hoop from side of
dishwasher_
3. PHace pan under end of drain hose. Pan wHHcoHHectany
water in drain hose.
4. PHacethe smaHHerdrain hose champ onto the smaHHend
of the drain hose.
hose clamp
./
5. Push the drain hose into the connector up to the stop
on the drain hose.
connector stop
\
6. Use pHiers to open champ and sHide champ onto
connector between stops on connector as shown.
hose clamp
stops
Secure dishwasher in cabinet opening
Tip Over Hazard
Do not use dishwasher until completely installed,
Do not push down on open door.
Doing so can result in serious injury or cuts.
1. Hfyou have not aHready done so, open dishwasher door
and pHace toweH over pump assembHy and spray arm of
dishwasher.This wiHHprevent screws from farthing into
pump area when securing dishwasher to countertop.
2. Check that dishwasher is stiHHHeveHand centered side to
side in the opening.
3. Secure dishwasher to countertop or sides of cabinet
with two, #10 x 1/2" PhiHHips-head screws.The
dishwasher must be secured to keep it from tipping
when door is opened. Do not drop screws into bottom
of dishwasher.
OR
4. Open door about 3 inches (7.6 cm) and check that space
between inner door and tub is equaH on both sides. If
spacing is not squall, Hoosen bracket screws and shift
tub.Tighten bracket screws.
5. Check that top of door does not contact screws,
brackets, or countertop. Hfit does, dishwasher must be
Howered and reoHeveHed.
6. Hfsecuring to sides of cabinet, repHace the pHastic
buttons.
7. Remove toweH from dishwasher.
8. ReinstaHHthe Hower dishrack
14