neno Bianco Manual De Instrucciones página 16

valve on the way out.
- Disassemble, wash and rinse all parts of the breast pump that come into contact
with milk, except for the pumping device.
- Use a mild dishwashing liquid or soap when washing the breast pump parts.
FIG. D
1. Washing (before first use and after use - in the sink):
a. Rinse all the detached parts (which have come into contact with the
breast and milk) in cold water to rinse off any milk residue and deposits
that have formed.
b. Soak in warm soapy water for 5 minutes, then wash and rinse.
c. Allow the parts to dry naturally. Store dry parts in a cool, dry place when
you are not using them.
2. Disinfection (before first use and once a day on the cooker):
a. Fill the pot with water so that all items placed in it are covered when
placed in the water. Bring to the boil. Place the breast pump parts in the
boiling water for 10 minutes. Do not boil.
b. Allow the items to dry naturally. Store dry kit items in a cool, dry place
when not in use.
FIG. E
3. Cleaning of the pumping device:
a. Wipe the pump unit with a soft, wet cloth and mild dishwashing liquid/
soap. Other cleaners or abrasives may damage the unit and its display.
b. Do not immerse the pump unit under water or wash it under running
water.
c. When not using the pump unit, store it in a cool, dry place.
06. BREAST PUMP ASSEMBLY
1. Wash your hands thoroughly with soap and water before touching the
breast pump and breast.
2. Connect the funnel, gasket and gasket cap to the joint.
3. Place the valve in the joint and screw the milk bottle onto the joint by
turning it clockwise until it stops.
4. Connect the tube to the seal cap. The tube can be connected to 1 or 2
bottles (See figure 6).
Councils:
a. Before each use, check the parts of the breast pump for damage. If necessa-
ry, replace damaged parts with new ones.
b. Always check the cleanliness of the components before using the device.
c. To avoid damaging the breast pump, make sure all its parts are dry before
use.
16