Cleaning And Maintenance - Bresser 40-25830 Instrucciones De Uso

Display System
1. Symbol for aim (Fig. 2, 1). The object to be measured should be aimed at the inner circle.
2. Distance display (Fig. 2, 6). The distance is indicated with three digits. If "- - - -" is shown,
no distance can be measured.
3. Distance unit: "M" (Meters; Fig. 2, 2) or "Y" (Yards; Fig. 2, 3).

Cleaning and maintenance

Remove the device from it's energy source before cleaning (remove battery).
Lenses (eyepieces and/or object lenses) should be cleaned with a soft, lint-free cloth (e.g. microfibre)
only. Do not use excessive pressure - this may scratch the lens. Dampen the cleaning cloth with a spec-
tacle cleaning fluid and use it on very dirty lenses. Protect the device from dust and moisture. Store the
device in the bag supplied or in its original packaging. Batteries should be removed from the device if it
is not going to be used for a long period of time. The mode button ("MODE") and the triggering button
("ON/MEASURE") should not be pressed at the same time, or it may cause trouble.
Troubleshooting
If Rangefinder cannot work anymore resulted from wrong operation, please remove the battery com-
partment lid (Fig. 1, no. 6) in order to cut down the current. Then close the battery compartment again
and see if it is OK. If the instrument cannot work all the same, maybe some other troubles encountered.
Devices which become defective during the warranty period can be returned to the dealer where the
device was bought.
16