Husky N3R482478W5R Guía De Uso Y Cuidados página 6

Assembly (continued)
3
ASSEMBLE BEAMS TO POSTS
□ Assemble Beam C (x2) to the pair of post assemblies at the same height location as the previously installed braces.
C
Inside View
C
Recessed ledge
Inside View
C
NOTE: Insert the tab from both ends of the beam through the slot on each set of post.
A
The recessed ledge of the beam must face up.
Helpful Tip: For stability lean the post assemblies against the wall during assembly if
installing alone.
NOTE: Once installed, press firmly down on the beam to make sure the tab is fitted
properly into the post slot on both sides. Use a rubber mallet to tap down lightly on
both ends of the beam to help seat the tabs into the post slots. DO NOT use force with
the rubber mallet, only a light tap is necessary.
IMPORTANT: Make sure each pair of beams (C) are installed at the same height
as the previous installed set of braces on each set of posts. This will ensure each
shelf will be leveled. (This will continue for each round of shelf level installations).
6
✓