Husky N3R482478W5R Guía De Uso Y Cuidados página 7

Assembly (continued)
4
ASSEMBLE WIRE DECK
□ Install the Wire Deck D (x1) onto the recessed ledge of the beams and braces.
5
ASSEMBLE SUPPORT HOOKS
□
WARNING: Must install support hooks. Failure to install
□
can cause wire deck to collapse under heavy loads.
□
□ Install Support Hooks E (x2) to both sides of the beams and wire deck as illustrated below.
□ The support hook should be orientated with the longer curve end installed into the hole of the beam and the shorter curve end
attached to the wire deck..
E
NOTE: Wire deck (D) should be
installed with the long 48 inch
horizontal wires facing the bottom.
D
E
Side View
E
Insert the Support Hook's
longer curve end into the
hole located in center of
beam's bottom ledge.
Please contact [Brand Specific Phone Number/must match cover] for further assistance.
bottom
Attach the top of the Support
Hook over the wire deck.
Push the beam slightly
inward if needed.
7
Please contact 773-475-3131 for further assistance.
✓
✓
✓
Support Hook correctly
engaged into the beam
and on the wire deck.
Repeat for other side.
BRAND SPECIFIC URL
HUSKY