Installing The Unit; Installation Procedure - Kenwood DMX8020DABS Manual De Instrucciones

• Do not press hard on the panel surface when
installing the unit to the vehicle. Otherwise
scars, damage, or failure may result.
• Reception may drop if there are metal objects
near the Bluetooth antenna.
Ñ
Supplied accessories for
installation
1
x1
2
(Black 1 m)
x1
3
[1]
(Gray 1 m)
x1
4
(3 m)
x1
DMX8020DABS only
[1]
Ñ

Installation procedure

1) To prevent a short circuit, remove the key
from the ignition and disconnect the ¤
terminal of the battery.
2) Make the proper input and output wire
connections for each unit.
3) Connect the wire on the wiring harness.
4) Take Connector B on the wiring harness and
connect it to the speaker connector in your
vehicle.
5) Take Connector A on the wiring harness and
connect it to the external power connector
on your vehicle.
6) Connect the wiring harness connector to the
unit.
Bluetooth antenna unit
5
x2
6
x1
7
(3.5 m)
x1
8
x1
7) Install the unit in your car.
8) Reconnect the ¤ terminal of the battery.
9) Perform the Initial Setup.
See Initial SETUP (P.8) in the Instruction
Manual.

Installing the unit

NOTE
• Make sure that the unit is installed securely in
place. If the unit is unstable, it may malfunction
(eg, the sound may skip).
Ñ
Trim plate
1) Attach accessory 6 to the unit.
Connection/Installation
Bend the tabs of the
mounting sleeve with
a screwdriver or similar
utensil and attach it
in place.
6
English
13