MESTIC SMART ADVENTURE MSSH-80 Instrucciones De Uso página 8

2. Note: make sure the surface on which the brackets are placed is clean, free of grease and dust, and dry. We
recommend roughing up the surface first before degreasing it thoroughly. Sealant or glue in a clean, dry
environment.
3. Make sure the adhesive forms a good seal on the mounting surface by applying an even, continuous strip in the
ridges at the bottom of the mounting brackets. The volume of the sealant or glue should be greater than the ridges.
4. Evenly and carefully press the panel down at the selected location.
5. Remove excess sealant or glue.
6. Let the sealant or glue dry thoroughly. Follow the instructions on the packaging of the respective product for this.
7. Note: preferably double-check the dimensions of the panel with the mounting brackets and the chosen location to
avoid errors. The sealant or adhesive is very difficult to remove once applied.
Routing cables:
1. Before you can install the roof penetration, find the most suitable location for your power cables to go through the
roof. Before drilling, check again that there are no other cables, pipes, etc. at the place you want to drill.
2. Once you are sure what your entry point is, drill holes of the right size.
3. Check that the cables are through the cable holes in the roof penetration and route the cables through holes drilled
in the roof to the desired location.
4. Note: make sure the surface on which the roof penetration is placed is clean, free of grease and dust, and dry. We
recommend roughing up the surface first before degreasing it thoroughly.
5. Apply an even, continuous strip of sealant or glue to the underside of the cable penetration and attach it to the
mounting surface, ensuring that the drilled holes are completely covered.
6. After the sealant or glue has cured, you can also apply a sealant to ensure a watertight seal around the cable
penetration.
Note: a solar panel must be connected to a battery system via a charge controller. For correct installation, follow the
instructions supplied with the product.
Parallel:
To connect 2 solar panels in a 12 V system, connect the panels in parallel by connecting the plus
to the plus and the minus to the minus.
Series and parallel connection
If more than one panel is used, they can be connected either in
series or in parallel.