MESTIC SMART ADVENTURE MSSH-80 Instrucciones De Uso página 9

Please note: The supplied cables have already been connected for you in the connection box. Do not disconnect this
and do not swap the plus and minus connections.
Maintenance
1. Normally, normal rainfall and wind are enough to keep the module glass clean. If necessary, you can clean the glass
with a soft cloth with a mild detergent and 50% water.
2. Note: do not damage the protective film on the back of the solar panels.
Recycling
This product bears the selective sorting symbol for waste electrical and electronic equipment This means
that this product must be handled pursuant to European Directive (2012/19/EU) in order to be recycled or
dismantled to minimize its impact on the environment. For further information, please contact your local
or regional authorities. Electronic products not included in the selective sorting process are potentially
dangerous for the environment and human heath due to the presence of hazardous substances.
Declaration of conformity
Hereby Gimeg Nederland B.V. declares that the device MSSH-80, 100, 140, 180, applies all basic requirements and other
relevant regulations listed in the European directive for electromagnetic compatibility (2014/30/EU) and low voltage
directive (2014/35/EU). If you require a full declaration of conformity, you can contact the address listed on the backside
of this manual.
Series:
To connect 2 solar panels in a 24 V system, connect the panels in series by connecting the plus
of one panel to the minus of the next panel.
Plus and minus connection view:
Open the junction box by gently loosening the tabs with a screwdriver.
1.
2.
3.
Junction box
Negative pole and connection
Positive pole and connection