Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS
6. INSERTING THE ASSEMBLED BRACKETS INTO YOUR DOOR UNIT
Now that the brackets are assembled, you are ready to attach the door unit to your lintel bar. (Recommendation:
This part of the installation might require 2 people – one person to hold the unit in place, while the other person
clamps the unit to the fireplace.)
• Insert the "T" of each T-Bracket into the slots found on the back of the door unit. Insert each "T" vertically into the
slot, and then turn it until it's horizontal. The assembled T-Brackets/Lintel Clamps should now be hanging loosely
in the slots.
6
O
7A. ATTACHING THE UNIT TO YOUR LINTEL BAR
• Open both the glass doors and the screen doors
on the unit.
• With the doors open, place the unit against the front
of your fireplace opening. (This is where you may
need assistance holding the unit in place while you
clamp it to the lintel bar.)
• With the unit in place, reach inside the fireplace
and position the T-Bracket/Lintel Clamp over the
lintel bar.
• Adjust the width of the T-Bracket/Lintel Clamp until
it is snugly grasping the lintel bar and tighten the
Small Machine Screw.
• With the T-Bracket/Lintel Clamp fitting snugly over
the lintel bar, tighten the thumb screw until the unit
is held firmly in place.
• With both thumb screws securely tightened, the unit
is now firmly attached to the top of your fireplace.
7A
Lintel Bar
Clamp
8
A
B
or
O
Publicidad
